Virtual Booth

This study aims to produce a centralized motor control system that allows it to be controlled semi-automatically. This project uses a PLC device (Siemen Logo) as a programming control. Conventional control is still the same using commonly used methods and wiring. The problem that is often experienced is that when there is a fault or problem in the programming control circuit, then the entire motor control in this MCC will not work. Therefore, this SEMI-AUTOMATIC MOTOR CONTROL CENTER project can be used to overcome the problem easily because with the presence of conventional additional circuits it can support if the programming control circuit has a problem. After testing, the project is ready to use. After analysis, this project can be used for lecturers to facilitate the motor control learning system especially for students in the field of Electrical Technology. In conclusion, this project can be used in all areas that use motors and can be used as a special learning module for the motor control module, especially at Datuk Seri Mohd Zin Vocational College.