Virtual Booth

This project focuses on automating plant watering using a soil moisture sensor and a water pump controlled by an Arduino Uno. The system detects the soil's moisture level and activates the pump when the soil is too dry. The wiring setup is as follows: Soil Moisture Sensor to Arduino: VCC to 5V, GND to GND, AOUT to A0. Relay Module to Arduino: VCC to 5V, GND to GND, IN to D8.Relay Module to Pump: NO (Normally Open) to VCC of the pump. Relay Module to Power Supply: COM to VCC of the power supply.Power Supply to Pump: GND of power supply to GND of the pump. The Arduino reads analog data from the soil moisture sensor. When the moisture level falls below a defined threshold, the Arduino sends a LOW signal to the relay (active LOW), turning on the pump to water the plant. Once the soil is moist enough, the pump is automatically turned off. This project provides a simple yet efficient solution for smart irrigation using low-cost components.